Send us an email sales@rotarykilnchina.com

Industry News

The latest industry information

Your Location: Home>News>Industry News
All News 159 Hongke News 6 Industry News 153

Causes of Various Problems in Slime Dryer

Published:2020-07-30

Causes of various problems in slime dryer


1. Short life of internal wearing parts.


Reason: Poor selection of internal materials and cutting corners will lead to easier parts damage and shorter service life.


2. The degree of dryness and wetness of the material is uneven, and the rod system cannot perform normal work.


Reason: ①Improper operation of the dryer.


     ②The raw materials form a mass.


3. After the dryer manufacturer has dried the material, the moisture contained in it must exceed the required specified value.


Reason: Feeding according to the production capacity, and the matching heat is not enough.


Remedy: increase the temperature of the furnace and reduce the number of feeds.


4. The final moisture content of the material after drying by the dryer is less than the specified value.


Reason: too much heat supply, or too little wet material feed.


Solution: Strengthen the feed quantity of wet materials and reduce the quantity of oil, gas or coal supply.


5. The lower sliding material bowl and the air inlet pipe are easy to block.


Reason: The matching furnace type is not suitable. You can use a high-temperature boiling furnace to change the air inlet method.


6. During use, the upper sliding bowl of the mine dryer is prone to blockage.


Reason: ①High initial moisture


     ②Material is highly viscous


     ③The arrangement of the secondary air duct is unreasonable.


7. The separator is too small.


Solution: Replace or modify the separator.


Previous:Safe Use and Maintenance of Dryer

Next:Causes of Overheating of Coal Slime Dryer Materials